LINDSAY - Hyaluronic Modeling Mask (Zipper) - 240g

Step 1: Before applying the alginate mask, the skin must be thoroughly cleansed. An active cosmetic product must be applied under the mask, it can be a serum, emulsion, ampoules with active substances, etc. Under the pressure of the mask, these products penetrate the skin better. After absorption of the applied product, an alginate mask is applied.

Step 2: Place the powder with a measuring cup and water (or activator) in a container in a ratio of 1:0.8 (for 100 ml of powder 80 ml of water), quickly mix with a spatula until it becomes homogeneous. Using a spatula, apply the mask in a layer of 3-5 mm on the cleansed skin of the face, leaving only the nostrils open. Apply quickly, so it doesn't have time to harden. When applying the mask to the face, it is recommended to follow the massage lines.

Step 3: During the next 10-15 minutes, the mask becomes rubbery and slightly decreases in volume, this process is called plasticization. The mask slightly tightens the skin of the face and the alginate mask does not require rinsing with water.

Step 4: Leave the mask on for 20-25 minutes until it hardens. Remove it in one layer, from chin to forehead. It can be easily removed in the form of a soft plastic impression that follows the contours of the face or body. You have to remove it in one movement from the chin to the forehead. Hair, eyelashes and eyebrows do not stick to the mask, so removal is not a problem.

Step 5: After removing the mask, an additional serum is applied to the face, followed by an emulsion or cream based on your usual care.

Diatomaceous Earth, Glucose, Calcium Sulfate, Algin, Tetrasodium Pyrophosphate, Magnesium Oxide, Cellulose Gum, Sodium Benzoate, Ultramarines, Mentha Piperita (Peppermint) Oil, Sodium Hyaluronate, Melaleuca Alternifolia (Tea Tree) Leaf Powder, Allantoin, Potassium Alginate, Betaine, Portulaca Oleracea Powder, Centella Asiatica Leaf/Stem Powder